INSTALLING YOUR ATTACHEMNT:

Installing your new ACP, Foam, or Leather Patch Holster Attachment is simple. Be sure to follow all appropriate safety protocols and work only with a completely empty holster. The provided loop section (fuzzy patch) must be installed on the holster body on the side of the holster that contacts your body. Prepping the surface can be achieved with an alcohol prep pad, Isopropyl Alcohol, or a mild dish detergent and cool water, or other thermoplastic safe solvent. The use of hand sanitizer gel is not recommended. No matter what is used it is critical to let the surface of the holster completely dry before installing the loop. The loop should be positioned in a similar fashion to what can be seen in the below image. Take your time, work from the center and make sure to not trap any air bubbles under the patch. Once it is on take a moment to make sure the edges are adhered well, especially around the edges, curves, and bends in the holster body.

 BREAK-IN:

If you are new to using foam or leather holster attachments, they do need some time to break in as they are designed to mold to your body and/or holster and that takes some use. One they break in they are very comfortable and provide additional levels of comfort and/or concealment not possible without one.

Additionally, the placement of the holster attachment is very important to function and overall comfort. We recommend starting with the wedge overhanging the muzzle of the holster by ½” to begin with. Movement of ¼” in any direction after setting the wedge up as described above will have an impact on both the comfort and concealability.